Altrad TRON-045-T45 Manuel D'instructions Et D'utilisation page 31

10. Maintenance
---------------------------------------------------------------------------------------------------------------
3. Oil tank
With a wire hook, take out the oil filter through the
filler port and clean in gasoline. When putting the
filter back into the tank, make sure that it comes to
the front right corner. Also clean off dirt in the tank.
Oil filter
4. Spark plug
0.6 ~ 0.7 mm
5. Sprocket
Check for cracks and for excessive wear interfering
with the chain drive. If the wear is considerable,
replace it with new one. Never fit a new chain on a
worn sprocket, or a worn chain on a new sprocket.
6. Front and Rear dampers
Replace if adhered part is peeled or crack is observed
on the rubber part.
■ Saw Chain
WARNING

It is very important for smooth and safe
operation to always keep the cutters sharp.
The cutters need to be sharpened when:
1. Sawdust becomes powder-like.
2. You need extra force to saw in.
3. The cut path does not go straight.
4. Vibration increases.
5. Fuel consumption increases.
Cutter setting standards:
WARNING

Be sure to wear safety gloves.
Before filing:

Make sure the saw chain is held securely.

Make sure the engine is stopped.

Use a round file of proper size for the chain.
Place the file on the cutter and push straight forward.
Keep the file position as illustrated.
After each cutter has been filed, check the depth
gauge and file it to the proper level as illustrated.
Appropriate gauge checker
GB
Make the shoulder round
Depth gauge standard
0.025"(0.64 mm)