Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Notice before operation!
Temperature and humidity readings could be affected by long-time-exposure under
VOC environment.
6. BUTTON INSTRUCTIONS
6.1 Power ON/OFF and Back-Light Button:
Press the
button to turn on the meter. Press and hold the button for 3 seconds to turn off.
Press
to turn on the LCD backlight. This makes it easier to read in dark environment. Press it
again to turn off back-light. The back-light will be automatically turned off after 30 seconds to save
battery power.
6.2 Data-Hold Button :
Press
button to freeze the data shown on the LCD screen. Press it again to exit Data-Hold
mode.
Note: When the unit is in the Data-Hold mode,
6.3 REC Button:
Press
button to start recording data. The
recording, press
Note: During recording period, most of the buttons are disabled, such as the
must be made before starting the data logger function.
Note: When the memory is full (32,000 recorders),
The data logger stops.
Note: When battery power is low ( "
started. If the battery is running low during data logging, it will stop recording automatically.
6.4 MAX/MIN/AVG Button:
Under this mode, the unit simultaneously monitors and stores the minimum, maximum and
average value in the memory. The unit will keep updating/refreshing the data.
To start:
(6) Press
button,
(7) Press
button again to show maximum data; the
(8) Press
button again to show average data; the
(9) Press
button again to show average data; the
button again.
" symbol lights up on the screen), data logger cannot be
symbol lights up on LCD, the reading shows the minimum data.
Mesureur de Dioxyde de Carbone (CO
,
, and
symbol will display on the screen. To stop
symbol will blink on the LCD screen.
symbol lights up on LCD.
symbol lights up on LCD.
symbol lights up on LCD.
5
buttons are disabled.
. All settings
)
2
Publicité
Chapitres
Table des Matières
