Bosch AdvancedTrimRouter 18V-8 Notice Originale page 16

16 | English
(31) Worklight
(32) K marking
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical data
Edge router
Article number
Rated voltage
No-load speed
Speed preselection
Connection for dust extraction
Tool holder
Weight according to
A)
EPTA-Procedure 01:2014
Recommended ambient tem-
perature during charging
Permitted ambient temperature
B)
during operation and during
storage
Recommended rechargeable
batteries
Recommended battery char-
C)
gers
A) Depends on battery in use
B) Limited performance at temperatures < 0 °C
C) The following chargers are not compatible with the PBA re-
chargeable battery: AL 1814 CV, AL 1820 CV, AL 1860 CV
Noise/Vibration Information
Noise emission values determined according to
EN 62841-2-17.
Typically, the A-weighted sound pressure level of the power
tool is 78 dB(A). Uncertainty K = 3 dB. The noise level when
working can exceed the volume stated. Wear hearing pro-
tection !
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 62841-2-17: a
2
K = 1.5 m/s .
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
1 609 92A 7UJ | (25.05.2022)
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping their hands warm,
AdvancedTrimRouter
and organising workflows correctly.
18V-8
3 603 JD5 0..
Rechargeable battery
V= 18
-1
Charging the battery
min 10,000–
30,000
Use only the chargers listed in the technical data. Only
u
●
these chargers are matched to the lithium-ion battery of
your power tool.
●
Note: The battery is supplied partially charged. To ensure
mm 6/8
full battery capacity, fully charge the battery in the charger
kg 1.4 (1.5 Ah) –
before using your power tool for the first time.
1.7 (6.0 Ah)
The lithium-ion battery can be charged at any time without
°C 0 to +35
reducing its service life. Interrupting the charging process
does not damage the battery.
°C –20 to +50
The lithium-ion battery is protected against deep discharge
by the "Electronic Cell Protection (ECP)". When the battery
is discharged, the power tool is switched off by means of a
protective circuit: The application tool no longer rotates.
PBA 18V...W-.
Do not continue to press the On/Off switch after the
u
power tool has automatically switched off. The battery
AL 18...
can be damaged.
Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
To remove the rechargeable battery, press the battery re-
lease button and pull the battery out. Do not use force to do
this.
Battery charge indicator
The battery charge indicator indicates the remaining battery
capacity or an overload when the power tool is switched on.
2
= 1.0 m/s , LED
h
3 × continuous green light
2 × continuous green light
1 × continuous green light
1 × slowly flashing green light
The 3 LEDs in the battery charge indicator flash simultan-
eously when the overload protection has been triggered. The
middle LED flashes when the temperature of the re-
chargeable battery is outside of the operating temperature
range and/or the power tool's temperature protection has
triggered.
Capacity
75–100 %
40–75 %
15–40 %
0–15 %
Bosch Power Tools