Troubleshooting - Angelcare AC017 Manuel De L'utilisateur

4.4 - BATTERIES
NURSERY UNIT LOW BATTERY INDICATOR:
The low battery yellow light indicator will flash and an alarm
will sound every 20 seconds when the batteries on the Nursery
Unit need to be replaced.
SENSOR PAD LOW BATTERY INDICATOR:
The Sensor Pad yellow light Indicator will flash and an alarm will
sound every 20 seconds when the battery on the Sensor Pad
needs to be replaced.

TROUBLESHOOTING

FALSE ALARMS
Turn OFF the Nursery Unit.
•
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the cot has a spring or slat base, place a hardboard between the cot base and the
Sensor Pad measuring at least 13'' x 13'' (33 x 33 cm) and 1/4'' (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements. Sensitivity may need to be adjusted
(refer to Step 4.3).
Pair Sensor Pad and Nursery Unit by pressing and holding the Nursery Unit Pairing button for 2 seconds until the light
•
blue flashes and you hear a beep.
ALARM WILL NOT SOUND
Avoid contact with the cot when the monitor is ON.
•
• Place cot near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the cot.
Turn OFF cot mobile, fans, loud music or anything else that may cause vibration.
•
You may need to decrease the sensitivity (refer to Step 4.3).
•
SENSOR PAD LIGHT INDICATOR FLASHING RED
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the cot has a spring or slat base, place a hard board
between the cot base and the Sensor Pad measuring at least 13'' x 13'' (33 x 33 cm) and 1/4'' (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements. Sensitivity may need to be adjusted
(refer to Step 4.3).
Power ON/OFF Light Indicator
Low Battery Light Indicator
Flashing green
Flashing yellow
Sensor Pad Light Indicator
Flashing red
Flashing white
Flashing yellow
Monitor is activated
Nursery Unit batteries are low
No movement is detected or
Sensor Pad lost connectivity
Monitor is paused
Sensor Pad battery is low
E
N
31