Turning On Your Monitor; Getting To Know Your Monitor - Angelcare AC017 Manuel De L'utilisateur

Sensor Pad
IMPORTANT
• Ensure the Sensor Pad is in the center of the cot – printed or Logo side up – on top of the hardboard. Check
the position is central before each use.
• BEFORE FIRST TIME USE: Test that the unit is ready for use – refer to the Full User Manual to check if
installation is correct.
STEP 3 - TURNING ON YOUR MONITOR
STEP 4 - GETTING TO KNOW YOUR MONITOR
4.1 TESTING THE SENSOR PAD:
2
1
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear a
single pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement
detected, Nursery Unit speakers will emit loud continuous
beeps.
Press and hold the Nursery Unit
ON/OFF button for
2 seconds until the Nursery Unit
Indicator flashes slowly in green.
1) Remove the mattress from the cot.
2) Place the Sensor Pad - Angelcare
up - in the center of the mattress. It should be
centered on the hardboard if your cot requires a
hardboard support.
3) Replace the mattress.
The Nursery Unit will emit a
sound and flash blue to
confirm pairing with the
Sensor Pad
NOTE:
If the green light does not appear but the red
light is flashing; or if there are false alarms,
adjust the sensitivity level (Step 4.3).
1) Move your hand lightly on the mattress.
2) Remove your hand from the mattress. After
15 seconds you will hear a pre-alarm sound and
the light will flash red.
3
3) 5 seconds later the Nursery Unit will emit loud
continuous beeps and the light will flash red
continuously - this is the movement alarm.
IF THE ALARM DOES NOT SOUND
• Avoid contact with cot while Sensor Pad
is in operation.
• Place cot near a supporting wall.
• Adjust Sensor Pad sensitivity level.
Turn OFF cot mobile, fans, loud music or anything
•
else that may cause vibration.
logo side
®
E
N
29