Positioning The Movement Sensor Pad - Angelcare AC017 Manuel De L'utilisateur

1.1 - INSERT THE BATTERIES
When using the Nursery Unit for the first time, you will need to insert 2 AAA alkaline batteries (not included).
1.2 - SELECT A LOCATION FOR THE NURSERY UNIT
Nursery Unit can be installed using the tabletop stand.
STEP 2 - POSITIONING THE MOVEMENT SENSOR PAD
2.1 - POWERING THE MOVEMENT SENSOR PAD
When using the Sensor Pad for the first time, you will need to insert the provided
CR3032 battery.
2.2 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your cot does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hard board between the crib base and the Sensor Pad, to ensure correct
operation.
The hardboard support must measure at least 33 x 33 cm (13" x 13") and 6 mm (1/4") thick. This
hardboard support must be larger than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except memory-foam mattresses,
hollow frame mattresses and water beds. The hardboard maintains a constant pressure on the
Sensor Pad, enabling it to detect the baby's movements even when the baby is at the edges of
the cot.
28
1) Remove the battery door with screwdriver and
insert 2 AAA batteries.
Place the Nursery
unit at least 3 feet
(1 meter) from
the crib
1) Remove the battery cover using a coin. Turn in
the direction of the arrow.
2) Place the included battery (CR3032) in the
compartment. Note: The + symbol should be
facing up.
3) Replace the battery cover (the two dots will line
up). The Sensor Pad
is now ON.
Hardboard