Angelcare AC017 Manuel De L'utilisateur page 30

TO STOP THE ALARM
IMPORTANT
• Test your monitor before first use.
• Test your monitor regularly to ensure it is functioning correctly.
• Test your monitor every time you move the Sensor Pad to a different place.
4.2 - PAUSING AND RESTARTING THE SENSOR PAD:
Allows you to pause the Sensor Pad if you remove baby from the cot,
e.g. for feeding or comforting.
IMPORTANT
• If you do not pause the Sensor Pad, the alarm will sound if there is no movement detected on the surface
of babys mattress after 20 seconds.
• Ensure to unpause the Sensor Pad before putting baby back in the cot.
4.3 - TO ADJUST THE SENSOR PAD SENSITIVITY LEVEL:
To ensure adequate monitoring of your child's movements, you can adjust the sensitivity of the Sensor Pad. Set a
high sensitivity for a newborn and a lower sensitivity as the child grows and gains weight. A thicker mattress will
also need a higher sensitivity.
Slide the Nursery Unit sensitivity level button to select between low, medium or high level.
For optimal results begin with the preset sensitivity
level and only increase/decrease if required.
IMPORTANT
• The Sensor Pad is not designed for use with adults, children or infants older than 24 months.
• Once you are finished using the Sensor Pad, please remove it from the baby's and store it away.
30
Place your hand back
on the mattress.
1) From the Nursery Unit, press the Pause button on the top right of
1
the unit.
2) The light will flash white when the Sensor Pad is paused. The Nursery
Unit will emit a single beep every 20 seconds to indicate movement
function is paused.
2
3) To unpause the Sensor Pad press the Pause button again.
OR
Press Pause
on the Nursery
Unit