Removing The Presser Foot; Attaching The Presser Foot; Adjustment Of Foot Pressure - Janome 1210DX Livret D'instructions

2
1
3
1
4
2 mm
3
3
4
2
2
1
2

Removing the Presser Foot

1. Turn off the power switch and unplug the
machine.
2. Raise the needle and the presser foot.
3. Press the lever located on the back of the foot
holder. The presser foot will drop off.
1 Needle
2 Presser foot lifter
3 Foot holder
4 Lever

Attaching the Presser Foot

1. Turn off the power switch and unplug the
machine.
2. Place the presser foot so that the pin on the foot
lies just under the groove of the foot holder.
3. Lower the foot holder to lock the foot into place.
4. Raise the presser foot lifter to check that the
presser foot is secure.
1 Groove
2 Pin
3 Lever

Adjustment of Foot Pressure

It is not necessary to adjust the presser foot's pressure for
normal sewing.
When you sew heavy or lightweight fabrics, turn the
adjusting screw:
–– clockwise for heavyweight fabric.
–– counterclockwise for lightweight fabric.
* For normal sewing, set the adjusting screw so
that it sits 2 mm below the top of the machine.
1 To decrease
2 To increase
3 Pressure adjusting screw
4 Top of the machine
20