Installation - Hendi 274125 Mode D'emploi

5. INSTALLATION

All of the operations described in chapter 5 may be
carried out exclusively by specialized technicians,
who must organize all the operational sequences
and use suitable equipment, in strict compliance
with the application regulations currently in force.
The machine must be installed indoors in a well-
lit and well-ventilated room with a fi rm, solid, level
fl oor (slope less than 2°); during installation, place
the machine well out of the reach of children and
unauthorized persons.
5.1. Accessories supplied
Pipe cleaner: for correct cleaning of the hot chocolate dispensing channel.
5.2. Installation-Positioning
It is necessary to check the following:
the site has been duly prepared for machine instal-
lation;
• that the premises are suitably well lit, aired, clean
and hygienic, and that the power socket is within
easy reach;
• the surface the machine will be installed on is
fi rm, fl at and solid;
• that the machine is placed at least 20 cm (7.8
inches) from the edge of the top used
Adeguate clearance must be left around the ma-
chine to enable personnel to work without any
The machine is of the attended type, and must be
installed in places where it can be monitored by
trained personnel.
Warning: it is forbidden to install the machine in
a place where it may be reached, touched and/or
operated by persons other than those specified in
section "1.2 Authorized persons".
The machine may only operate in places with an am-
bient temperature ranging between 10°C (50°F) and
32°C (89,6°F).
constraints and also to leave the work area imme-
diately in case of need.
Fig. 5 shows the minimum clearances for installation
Note: Leave a 25 cm (10 inches) space in the upper part.
Fig. 5 shows the clearances required for access:
• the controls situated on the left side,
• machine parts so that they may be serviced in the
event of a fault.
Important note: when lifting the machine, do not use
Fig. 5
the product dispenser unit (tap), drainage pipe, water
level indicator tray, bowl hook on handles or the bowl
itself; grip the bottom machine body. Any damage
to the machine deriving from failure to follow these
rules will not be covered by the warranty.
After positioning the packing container in the vicinity
of the installation site, proceed as follows:
• open the front pad of the packing container;
• lift the machine and remove it from its packing;
• then position it on the prepared site.
Before the machine is operated the first time, its
components must be thoroughly cleaned; for fur-
ther details see the relevant section herein.
EN
9