• The appliance is properly plugged in;
• There is not a power cut in progress;
• The breakdown is not one of those described in the table at the end of this manual.
IMPORTANT: If the mains cable supplied is damaged, it must be replaced by the manufacturer,
a centre approved by the brand or by the retailer. In all cases, it must be replaced by qualified
personnel, so as to avoid any risk of injury.
19. Problems and solutions
You can solve many simple problems with your wine cooler yourself, thus avoiding having to
contact your after- sales department. Try the following suggestions.
Problem
Appliance does not run • Appliance is not plugged in
Appliance is not cold
enough
The compressor starts
and stops frequently
LED lights do not
operate
Vibration
The appliance makes a
lot of noise
Possible causes
• Appliance is not turned on
• Check the voltage of the installation
• Check if the circuit breaker or fuse has blown
• Check the temperature control setting
• Check if ambient temperature is outside the operating temperature
of the appliance
• The door has been opened too often
• The door is not closed properly
• The door does not seal properly
• Insufficient free space around the appliance
• The external temperature is too high
• A large quantity of bottles has been put into the cooler
• The appliance has been frequently opened
• The door is not properly closed
• The cooler has not been set correctly
• The appliance is not plugged in
• The fuse has blown
• LED lights are broken
• The light switch is off
• Check and ensure that the appliance is level
• It is normal to hear a noise which resembles circulating water as this
is produced by the coolant gas
• At the end of a cooling cycle, you can hear the noise of water
circulating.
• Expansion and contraction of the internal walls may cause a cra-
cking sound.
• The appliance is not level
• Check if the fan is in good condition
77
GB