Check The Charge Level Of The Power Bank With Compressor; Charging The Power Bank With Compressor; Charging Mobile Phones And Tablets - ULTIMATE SPEED UPK 10 E2 Consignes D'utilisation Et De Sécurité

compressor is not started or if no
consumables are connected.
z Check the charge level
of the power bank
with compressor
Switch on the power bank with
„
compressor
for the power bank
During charging, the indicator
„
lights will flash
The number of permanently lit
„
indicator lights
charge level of the power bank
with compressor
If the device is fully charged, all
„
four indicator lights
permanently lit.
Indicator lights
0 permanently lit
1 permanently lit
2 permanently lit
3 permanently lit
4 permanently lit
z Charging the power
bank with compressor
Connect the power bank with
„
compressor
the AC adapter
To do so, plug the cable from the
„
AC adapter
port (5 V
14
GB/IE/NI/CY/MT
by using the switch
1
.
9
.
13
shows the
13
.
1
will be
13
Charge level
0%
25%
50%
75%
100%
to a socket using
1
.
24
into the charging
24
/2 A) on the
10
power bank with compressor
and then plug into a mains power
socket.
Attention: Only use the AC
adapter as supplied
device!
Note: An undervoltage protection
circuit is installed in the power bank
with compressor
device from damage. This prevents
a deep discharge of the power bank
with compressor
cally switches the device off once
the battery is fully discharged. In this
case, only one of the four
blue indicator lights will be lit
In this case, no more energy can
be obtained and the compressor
function will be deactivated. Please
recharge the power bank with com-
pressor using an AC adapter
1
z Charging mobile
phones and tablets
Press the power switch for the
„
power bank with compressor
once.
Connect a suitable USB
„
charging cable to the USB port
(5 V /2 A)
(5 V /1 A)
into your mobile phone or tablet.
The charging process starts
„
automatically.
with the
24
to protect the
1
and automati-
1
.
13
24
or the USB port
11
and then plug it
12
1
.
9