Maintenance And Change Of Size - FAR RAC 181 Traduction Des Instructions Originales

MAINTENANCE AND CHANGE OF SIZE (pic. f15-f16-f17-f18))
The prolonged use of the riveting tool can cause the slipping of the clamps on the nail because of the impurities. For this reason,
it is necessary to lubricate the clamps after cleaning. However, if clamps are worn out and their proper functioning compromised,
they must be replaced. First remove the head which carries the nozzle (I), by means of a standard spanner of 27 mm. Then, by
using two standard spanners of 11 mm and 16 mm, remove the cone (P) and extract the clamps (Q).
When replacing the nozzle (L), use the proper supplied wrench and screw the removed nozzle in it in order to avoid losing the nozzle.
WARNING!
Disconnect air feed when performing those operations.
f15
I
f16
P
16 mm
22
27 mm
11 mm
GB
f17
P
Q
f18
L
Date 04-2017
RAC 181
Revisione - 01