Listening To The Radio; Tuning Into Fm/Am Radio Stations; Presetting Fm Stations Automatically (Auto Preset) - Onkyo CR-245 Manuel D'instructions

Listening to the Radio

INPUT

Tuning into FM/AM Radio Stations

When tuned to a station, the Tuned (
appears. When receiving a stereo FM signal, the FM ST
indicator appears as well.
FM „ „ 8 7... „ 5 M„ „ H „ „ z
The [MODE] button is used to select Mono mode or
Auto mode. In Auto mode, the output will be stereo or
mono depending on the station being received. In Mono
mode, the output will be mono regardless of the station.
1 Press the [TUNER] button on the remote
controller, or the [INPUT] button on the top
panel, repeatedly to select "FM" or "AM".
2 Use the TUNING []/[] buttons to tune
into a station.
Each time you press the TUNING button, the
frequency changes 0.2 MHz steps for FM and
10 kHz steps for AM.
If you press and hold the TUNING button, the
frequency will change continuously. Once you
release the button, tuning will stop automatically
when a frequency on which a radio station is
broadcasting is found. If you want to interrupt this
process, press the [CLEAR] button.
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, press the
[MODE] button to switch to Mono mode and listen to
the station in mono.
26
En-
TUNER
TUNING C/U
ENTER
MODE
Presetting FM Stations Automatically
(Auto Preset)
) indicator
With the Auto Preset function, you can automatically
preset all of the FM radio stations available in your area
in one go. Presets make it easy to select your favorite
stations and eliminate the need to tune the radio
„ „
manually each time you want to change stations.
As an alternative to this Auto Preset function, there's
also a Manual Preset function that lets you manually
preset individual FM stations (see page 27).
Auto Preset Caution!
Any existing presets will be deleted when the Auto
Preset function is run.
1 Press the [TUNER] button, or the [INPUT]
button on the top panel, repeatedly until
"FM" appears.
Make sure the FM antenna is positioned to achieve
the best possible reception.
2 Press the [PRESET MEMORY] button.
"Auto Preset?" appears on the display.
3 To start the Auto Preset function, press
[ENTER].
Up to 30 stations can be preset and presets are
stored in frequency order.
If you want to interrupt the Auto Preset process,
press the [CLEAR] button.
Note:
• Depending on your location, a preset may be stored
with no station, and you'll hear only noise when you
select it. In this case, delete the preset (see page 27).
PRESET
MEMORY
CLEAR