Connecting Antennas; Connecting Other Components - Onkyo CR-245 Manuel D'instructions

Connecting Antennas

This section explains how to connect the supplied indoor
FM antenna.
The CD receiver won't pick up any radio signals if no
antenna is connected, so you must connect the antenna to
use the tuner.
Insert the plug
fully into the jack.
Note:
• Once your CD receiver is ready for use, you'll need to
tune into a radio station and position the antenna to
achieve the best possible reception.
Tip:
• If you cannot achieve good reception with the
supplied indoor FM antenna, try a commercially
available outdoor FM antenna instead.

Connecting Other Components

Analog audio
cable (RCA)
e.g., casette tape deck
Connecting the AM Loop Antenna
The supplied indoor AM loop antenna is for indoor use
only.
1
2
■ Adjusting the AM Loop Antenna
Adjust the location and position of
the AM antenna while listening to
an AM station to achieve the best
possible reception.
CD receiver
Powered
subwoofer
Assemble the AM loop antenna, inserting
the tabs into the base, as shown.
Plug the AM loop
antenna into the
AM antenna jack,
as shown.
TV, projector, etc.
(Connector type varies
from country to country.)
VIDEO
IN
To wall outlet
15
En-