Installation Considerations - Wolf ICBWWD30 Instructions D'installation

Installation Considerations

Installation Considerations
MODEL ICBWWD30
• Model ICBWWD30 must be installed with a Wolf stain-
less steel or integrated drawer front. Specific installa-
tion instructions are included with the drawer front.
• The warming drawer platform must be able to support
91 kg.
• The warming drawer platform must be a minimum of
25 mm above the toe kick to allow for the overlap of
the warming drawer trim.
• For undercounter installations, 597 mm from the
bottom of the warming drawer opening to the floor
is typical.
COMBINATION INSTALLATIONS
• Model ICBWWD30 may be installed in combination
with a Wolf built-in oven and/or microwave. Additional
clearance between warming drawer and oven openings
may be required. To allow the warming drawer trim and
the oven trim to meet, a 22 mm platform may be used
to separate the two openings. This will act as the
support platform for the oven and the anti-tip device
for the warming drawer. An anti-tip block may be
installed at the rear of the cabinet in place of the
platform. If the warming drawer is installed above an
oven, a 22 mm platform is required to allow for clear-
ance of overlaps.
• Model ICBWWD30 may be installed below a Wolf
cooktop or sealed burner rangetop. Allow enough
room for gas and electrical connections for the
cooktop.
• Model ICBWWD30 may be installed next to or above
another Wolf warming drawer.
IMPORTANT NOTE: For combination installations, refer
to installation instructions provided with the other Wolf
products for additional specifications.
ICBWWD30 Drawer Front Options
IMPORTANT NOTE: Model ICBWWD30 must be installed
with a Wolf stainless steel or integrated drawer front.
An E Series or Pro drawer front with handle is recom-
mended. These front panels are designed on the E Series
front panel platform and are available with a tubular,
curved or pro handle.
The Pro drawer fronts with pro handle are designed to be
installed below a sealed burner rangetop so the panel
aligns properly with the front of the rangetop.
For information on integrated door front, refer to page 8.
OVERALL DIMENSIONS
A
264
mm
19 mm
759 mm B 578 mm
911 mm
OR
718 mm 19 mm
546 mm
B
Drawer Front Panel and Handle
L SERIES A
Tubular Handle 22 mm
E SERIES A
Curved Handle 29 mm
Tubular Handle 29 mm
PRO SERIES A
25 mm Thick / Pro Handle 29 mm
51 mm Thick / Pro Handle 54 mm
Dimensions may vary ± 3 mm.
6
229
mm
B
89 mm
B
70 mm
89 mm
B
89 mm
114 mm