Wolf Warming Drawer - Wolf ICBWWD30 Instructions D'installation

Wolf Warming Drawer

Warming Drawer Installation
IMPORTANT NOTE: This installation must be completed
by a qualified installer.
Read this entire installation guide prior to installation and
save for the local inspector's reference. The homeowner
should keep this installation guide for future reference.
Any questions or problems regarding installation of the
warming drawer should be directed to your Wolf dealer.
IMPORTANT NOTE: This appliance must be installed in
accordance with all local codes. The correct voltage, fre-
quency and amperage must be supplied to the appliance
from a dedicated, grounded circuit which is protected by a
properly sized circuit breaker or time delay fuse. The
proper voltage, frequency, and amperage ratings are listed
on the product rating plate.
Record the model and serial number before installing the
warming drawer. Both numbers are listed on the product
rating plate, located on the left front floor area of the inner
cabinet. To access the rating plate, the drawer must be
fully open. Refer to the illustration below.
RATING
PLATE
Location of rating plate.
Wolf Warming Drawer
Model Number ICBWWD30
Serial Number
Before You Start
• Proper installation is the responsibility of the installer.
• Model ICBWWD30 must be installed with a Wolf stain-
less steel or integrated drawer front. Make sure you
have the accessory drawer front called for in your
installation. Specific installation instructions are
included with the drawer front.
• Make sure cabinetry meets the minimum dimension
requirements for your specific installation.
• Check with local utilities for electrical codes that apply
in your area. Local codes vary. Installation, electrical
connections and grounding must comply with appli-
cable codes.
• This appliance must be properly grounded. Refer to
electrical requirements on page 8.
• Make sure you have the tools and materials necessary
for proper installation.
wolfappliance.com
TOOLS AND MATERIALS REQUIRED
• Minimum 19 mm thick lumber for the solid platform
that supports the warming drawer—must be able to
support 91 kg
• Wood screws and hardware to install the platform
• 51 mm x 51 mm or 51 mm x 102 mm lumber for anti-tip
block
• Power saw
• Level
• Drill and 1,6 mm bit, 13 mm bit also for integrated
drawer front application
• Phillips screwdriver
• 2 wood screws (provided)
• Wood cleats (optional)
5