Lighting Instructions
WARNING!
WARNING!
valve.
Main Tube Burner
1. Open grill lid.
2. Push and turn any main burner
knob slowly to the 'hi' position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
or light with a match.
5. If lighting the unit with a match,
clip the match into the supplied
lighting rod. Hold the lit match down
through the grill and sear plate while
turning the corresponding burner
valve to high.
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
N415-0220 JAN 23.18
Lights Left Burner
Rear Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Rear Burner Lighting
Lighting
2. Remove the warming rack
3. Clip a match into the supplied
lighting rod. Hold a lit match to
right end ports of rear burner.
Turn rear burner to high.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use the rear burner (rotisserie burner) with the main burners operating.
Side Burner Igniter
Centre Burner
Right Burner
(If equipped)
1. Open grill lid.
1. Open/Remove side burner cover.
2. Push and turn side burner control
3. Press and hold igniter button until
4. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
Side Burner
Off Position
Side Burner Lighting
(If equipped)
to high position.
burner lights, or light by match
match.
www.napoleongrills.com
7
EN