Kübler 573 Serie Mode D'emploi page 47

The direction of
operation of the
Hysteresis setting
depends on the selected
switching characteristics
„GE" or. „LE".
See adjoining figure
Where the switching outputs have been set to dynamic operation, the output impulse time is
always 300 msec. (fixed time, only factory adjustable)
Operational settings for presets:
The settings for the Preselection values appear at the beginning of the operational parameters:
Menu Text
Preselection 1
Preselection 2
Actual switching state of the outputs:
At any time you can find out the actual switching state of the outputs. For this, just push the
ENTER key shortly during normal operation. The display will then provide one of the following
information for the next two seconds:
Display Meaning
Both outputs are OFF (output transistors in high impedance state)
Both outputs are ON (output transistors in low impedance state))
Output 1 is ON
Output 1 is OFF
6.573.011.E00_7b_e.doc / Sep-08
Display value
Output 2 is OFF
Output 2 is ON
Hysteresis
Preset value
Hysteresis
GE=Greater/Equal
LE=Lower/Equal
Setting Range Default
-99999 ... 99999 10000
-99999 ... 99999 5000
Page 19 / 28