How To Operate The Keys; Normal Display State - Kübler 573 Serie Mode D'emploi

4. How to Operate the Keys

The unit uses 3 front keys for all setup operations. Subsequently, the key functions will be
named as shown in the table below.
The functions of the keys are depending on the actual operating state of the unit.
The following three operating states apply:
•

Normal display state

•
Setup state
a.) Basic setup
b.) Operational parameter setup
•
Teach operation
4.1. Normal display state
You can only change over to the other states while the unit is in the normal
display state.
Change over to
Basic setup
Operational
parameter setup
Teach operation
The Cmd key is only used with the Tare and Reset function, and for the Teach procedure with
linearisation (see section 8).
6.573.011.E00_7b_e.doc / Sep-08
ENTER SET
Key operation
Keep ENTER and SET down simultaneously for 3 seconds
Keep ENTER down for 3 seconds.
Keep SET down for 3 seconds
Cmd
(Command)
Page 9 / 28