Setup Procedure; Basic Parameters - Kübler 573 Serie Mode D'emploi

6. Setup Procedure

6.1. Basic Parameters

In general, the parameters described subsequently must be set with the very first
commissioning of the unit only. For best comprehensibility, this section describes setup of all
display functions only, and settings applicable to preselections and switching outputs are
described separately.
Menu Text
Mode of operation
Brightness of the display
„ 100"
„ 80"
„ 60"
„ 40"
„ 20"
Update time of the display
Updates the display every x.xxx seconds. Setting range from
0.050 to 9.999 seconds.
Keypad interlock code
Mode of linearisation
6.573.011.E00_7b_e.doc / Sep-08
Single input operation (input A only)
Dual input operation (input A and input B separately)
Sum operation (input A + input B)
Differential operation (input A – input B)
Dividing operation (ratio A : B)
Multiplying operation (product A x B)
100% of maximum brightness
80% of maximum brightness
60% of maximum brightness
60% of maximum brightness
20% of maximum brightness
Keypad enabled continuously
Keypad locked for any access
Keypad locked, except for access to preselections
Pres 1 und Pres 2
No linearisation. The corresponding parameters will
not appear in the menu.
Linearisation for the numeric range 0 – 99999.
Interpolation points to be set in the positive range
only (negative values will appear as a mirror).
Linearisation over the full range
–99999 to +99999
Default
„100"
„0.300"
Page 13 / 28