EUROM Flameheater Round 11000 Manuel D'utilisation page 31

Step 5
Step 6
Attach the reflector cap
a. Screw the 3 tap screws with 3 washers at the
bottom and 3 washers at the top on the top of the
flame screen.
b. Attach the reflector cap to the tapping screws and
secure it with the 3 washers and the 3 wing nuts.
Required material:
Step 7
Attach the upper mesh protection to the heating
house
Connect the gas hose to the gas pressure
regulator with spanner 17 and then the gas
pressure regulator to the gas bottle (note: left-
hand thread). Before mounting the gas
pressure regulator on the gas bottle, check
whether the black sealing rubber is present in
the union nut and is in good condition. Screw
the union nut of the pressure regulator
counter-clockwise (left-hand thread) onto the
gas bottle connection of the gas bottle. If
necessary, re-tighten it with the pipe wrench:
the seal must be leak-free, but do not damage
it by turning it too tightly! Place the gas bottle
in the gas bottle housing
.
31