Publicité
WhaT TO dO If...
pROBLEmS
none of the lights are
lit.
the heating plate does
not heat up
there is no steam
output
Water stains on the
cover
unexpected noise in
the press
a knocking noise from
the generator
the water container
cannot be inserted
Causes
- Power supply problem
- other
- thermostat dial at the off
position
- other
- the water reservoir is empty
- the handle has not been held
in steam position (press is half
closed)
- the anti-scale cartridge has
not been inserted
- the anti-scale cartridge is
incorrectly inserted.
- other
- over use of steam
- other
- no water left in the reservoir
- the reservoir is incorrectly
inserted or has not been
inserted.
- other
- a small residue of water in
the generator
- the anti-scale cartridge is the
wrong way round or has not
been correctly inserted
SOLUTIONS
- Check the plugs and mains.
- go to your local dealer.
- Put the dial to the desired
temperature.
- go to your local dealer.
- fill the water reservoir
- lift up the handle and bring it
down again midway to call for
steam
- insert an anti-scale cartridge
into the reservoir
- insert an anti-scale cartridge
into the reservoir
- see your local dealer
- leave the press closed for a
few seconds to dr the cover
- iron two or three articles wit-
hout calling for steam
- see your local dealer
- fill the reservoir.
- insert the reservoir and push it
fully in.
- see your local dealer
- no risk
- remove the container and
check that the anti-scale
cartridge has been correctly
inserted
27
Publicité
