Videotec UPTIRPS Manuel D'instructions page 6

6 Assembling and installing
Before starting any operation, make sure
the power supply is disconnected.
The assembly and installation must be
performed only by skilled personnel.
6.1 Installation
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
6.1.1 Open the box
Open the box taking care not to damage the seals.
Fig. 1
After installation and wiring, close the
product again.
Position the gaskets correctly and tighten
the cable glands.
4
6.1.2 Board description
Connect the safety earth to the relative
terminal of the power supply connector.
The board may appear different to that
illustrated.
Depending on the product version, the
board may not be equipped with all
functions.
F2
Fig. 2
BOARD DESCRIPTION
Connector Function
J5 Day/Night status
P1 Sensitivity adjustment trimmer
F2 Fuse holder and fuse
Tab. 1
P1
J5
MNVKUPTPSUL_1423_EN