Videotec UPTIRPS Manuel D'instructions page 10

7 Configuration
The product has already been set in the factory for
optimal operation under a range of conditions. The
product features can be suited to the operating
situation.
Use trimmer P1 to adjust the intervention threshold
of the twilight sensor. (6.1.2 Board description, page
4).
By rotating the trimmer clockwise, the night mode
changeover is anticipated (at a greater luminous
value). By rotating the trimmer anti-clockwise,
the night mode changeover is delayed (at a lower
luminous value).
We recommend making the adjustments under the
actual conditions in which the spots will be used.
The switching on of the red LED on the board stands
for the activation of the night-time mode.
8 Maintaining and cleaning
8.1 Maintaining
Maintenance must be carried out by
personnel trained to operate on electrical
circuits.
8.1.1 Fuses replacement
The used fuse is described below.
T8A L 250 (F2, 6.1.2 Board description, page 4).
9 Disposal of waste
materials
This symbol mark and recycle system
are applied only to EU countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
8
10 Troubleshooting
Ask for assistance from skilled personnel if:
• The unit is damaged after being dropped;
• There is noticeable deterioration in performance
of the unit.
• The unit does not work properly, even though
all the instructions in this handbook have been
followed.
The unit does not power Pan &
PROBLEM
Tilt.
Fuses blown.
CAUSE
SOLUTION Make sure the power supply data
plate values coincide with the values
for the installation. Check that the
green LED inside the box is on. Make
sure there are no current overloads
or short circuits. Change the fuses.
The unit does not allow the
PROBLEM
Day/Night changeover of the
P&T.
Incorrect wiring or incorrect
CAUSE
trimmer regulation
SOLUTION Ensure that the board STATUS
contacts and the alarm contacts are
connected. Reset the twilight sensor
sensitivity.
If one of the problems listed persists,
contact the authorised service centre.
MNVKUPTPSUL_1423_EN