Sunbeam FPSBSM3481 Serie Mode D'emploi page 4

p T s
reparIng he Tand
mIxIng
r l
aIsIng and OWerIng
m h
The IxIng ead
To tilt mixer head, pull up Tilt Release button
and slowly lift mixer head until it locks in the upright
position. (Figure B)
To lower mixer head, grab head, pull up Tilt Release
button and gently lower mixer head, ensuring it locks
in downward position. A "click" sound will indicate
the mixer head has locked securely into position.
(Figure C)
O s C
peraTIng peed OnTrOl
The speed control dial is used for turning the mixer
ON and OFF and for selecting its 6 mixing speeds.
Rotate the speed control dial in a CLOCKWISE
direction to increase mixing speed, and in a
COUNTERCLOCKWISE direction to decrease
mixing speed.
Rotate the speed control dial until the indicator is
aligned with the indicator line for the desired speed.
(Figure D)
Pulse Setting:
Turn Speed Control Knob counter-clockwise for the
desired time.
NOTE: Always begin mixing at the lowest possible
speed setting, then gradually move to desired
higher speed to avoid splashing ingredients
out of bowl.
DO NOT OPERATE WITHOUT ATTACHMENTS AND
SEE NEXT SECTION "INSTALLING YOUR ATTACHMENTS"
TO BEGIN.
6
m f u
Ixer Or se
Figure A
K :
nOb
Figure B
Figure C
Figure D
I Y a
nsTallIng Our TTaChmenTs
T a b
O TTaCh OWl
(figure A):
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. Pull up Tilt Release button and tilt mixer head back.
4. Place bowl on bowl locking plate.
5. Turn bowl gently in a clockwise direction to lock into
place.
6. Plug into a grounded 3 prong outlet.
T r b
O emOve OWl
(figure B):
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. Pull up Tilt Release button and tilt mixer head back.
4. Turn bowl counterclockwise and lift off locking plate.
T I a
O nsTall TTaChmenTs
(figure C):
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. Pull up Tilt Release button and tilt mixer head back.
4. Align the key positions of the whisk shaft and
attachment, push upward.
5. Twist clockwise so that pin aligns with attachment
notch and clicks into position.
6. Plug into a grounded 3 prong outlet.
NOTE: Align the key positions of the whisk shaft
and attachment.
T r a
O emOve TTaChmenTs
(figure D):
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. Tilt mixer head back.
4. Press attachment upward as far as possible and
turn counter-clockwise.
5. Pull attachment from whisk shaft.
NOTE: It is recommended to scrape food off attachment
with a spatula/scraper before removing.
Figure A
Figure B
Figure C
Figure D
7