Maintenance And Care - MCS Master DHP 20 Mode D'emploi

ð The device switches off automatically
as soon as the set target humidity is
reached. The device remains however
in ready mode. If the target humidity is
again exceeded, the device is automat-
ically restarted.
Pumping off condensate (before moving
device to a different location)
ü The device must not be in defrost mode
(yellow indicator must be off).
1. Set the device switch to position [II].
ð The condensate pump starts to
pump the condensate through the
drain hose into the drain or the on-
site drain / collecting vessel.
2. As soon as there is no condensate left in
the tank, quickly set the switch to posi-
tion [0], to prevent the pump from run-
ning dry.
Switching device off
1. Set the device switch to position [0].
ð The indicator in the device switch is off
and the device is shut down.
NOTICE! For planned prolonged stand-
stills, pump off the condensate before
shutting down the device.

9 Maintenance and care

WARNING! Risk of injury from inhaling
harmful substances
Ü Depending on the location of operation,
the components of the device may be-
come contaminated with mould or other
hazardous organisms or substances.
Ü When using compressed air to clean the
device and/or the filter, work in a well-
ventilated area, preferably outdoors.
Ü During cleaning, wear safety goggles
and a breathing mask.
ATTENTION! Risk of damage to property
Ü Detergents can cause damage to sur-
faces. Use only mild detergents.
Ü Use only approved original spare parts.
Cleaning housing and filter
The cleaning intervals for the device depend
on the actual operating conditions. Check
and clean the device regularly.
If the device is used for drying at construc-
tion sites, it must be checked and cleaned
after each use; the air filter must be re-
placed at least once a week.
1. Switch off the device at the device
switch.
2. Disconnect the power plug.
3. Clean the housing with a damp, lint-free
cloth and a mild detergent. The original
gloss can be restored with polish.
4. Remove the filter holder by the recessed
grip.
5. Take the filter from the housing.
For foam filters: Clean the filter thor-
oughly with a mild detergent and water.
Let the filter dry.
6. Check the drain fitting and the connected
drain hose for damage. Replace dam-
aged components.
7. Insert the new or cleaned filter in the fil-
ter holder.
9