Steba AS 100 Mode D'emploi page 13

Assembling
∙ Remove the carriage table 2) from the underside of the device (underside of the
carriage lead). Then open the folded carriage lead completely.
∙ Insert the hand guard 4) into the carriage table 2).
∙ Place the carriage at a 90 ° angle on the carriage lead and let it sink in the direction
of the blade.
∙ Then hang the food holder 5) on the hand guard.
Usage
∙ Do not connect the device during assembly!
∙ Only use the device when it is completely assembled!
∙ Take the cable from the cable storage and connect the device.
∙ Simultaneously press the safety switch (rear) and the power button (top) to start
the device. The power button must always be held down.
∙ The slice thickness can be selected between 0 and 17 mm with the adjusting
wheel 7).
∙ Press the food against the moving blade without applying too much pressure on
the carriage. Always use the hand protection and food holder.
∙ Tip: if you want to cut different foods one after the other (e.g. cheese, sausage), it
is advisable to cut a slice of bread in between to prevent odour and taste transfer.
Storage
∙ Remove the carriage from the lead and fold the carriage lead onto the device.
∙ Stow the cable in the cable compartment.
Protecting the motor:
∙ Do not operate the device without food
∙ Do not let the device run for more than max. 5 minutes.
∙ Let the device cool down between the work steps.
13