Hoppe FingerScan Notice De Montage Et D'utilisation page 29

3. If the finger is not recognised, the red LED lights up. The finger must be drawn across the
sensor again. If non-recognition continues repeatedly, the finger may not be authorised (see
5.10).
5.8.1 Reset: Deleting all saved fingerprints
To delete all saved fingerprints, a reset must be carried out. The device is then back in the de-
livery setting. To do this, a master finger is first drawn over the sensor twice in quick succession
and then once again (three times in total):
• After the second reading of the master finger, the delete mode is initialised (both LEDs flash).
• After the third reading of the master finger, the delete process is started (green LED lights
up).
• The device subsequently returns to delivery setting (red + green LEDs are constantly lit)
Alternative procedure using the remote control
Precondition: The device is in operation setting (no LED is lit).
The delete code (6-digit code, factory setting) is shown on a sticker attached to the remote
control.
Entry using the infra-red remote control (held in front of the LED):
Each press of the keys is confirmed by the green LED briefly lighting up. The device sub-
sequently returns to delivery setting (red + green LEDs are constantly lit). If the code is not
accepted, the red LED lights up briefly.
5.8.2 Deleting individual saved finger prints in the Advanced mode
Requirements: The device is in operating mode (no LED lit).
1. Draw a master finger over the sensor (red and green LEDs light up briefly).
D
2. Press the key on the remote control.
3. Enter the index/identification number of the finger that is to be deleted.
OK
4. Press the key.
5. Draw the master finger over the sensor again (red + green LEDs light up briefly).
5.9 Altering the delete codes
It is imperative to alter the 6-digit delete code set by the factory for safety reasons. The
DA Delete code
English 29
OK