Burkert 8642 Manuel D'utilisation page 23

Out of Service (O/S)
Manual 1 (Man)
Automatic (Auto)
Remote Cascade
(RCas)
The layout of a function block or transducer block is checked by the Modus
parameter. The values of the subindex mode are defined as follows:
1. Target
This is the mode which is requested by the user. The values which are allowed
by the allowed mode parameter are limited by target . The modes are
determined by the bit sequence in the following manner:
Bit
7
4
3
1
The "automatic" modes which are used in this profile are Auto and RCas ; Ma-
nual mode : Man . In the O/S mode, the normal algorithm is not carried out, and
any alarm present will be reset.
2. Current
This is the current mode of the component, which can be different from the
target mode, which is based on the operational conditions.
22 - 8642
The block is not being evaluated. The output is
maintained at last value or, in the case of output
class function blocks, the output may be main-
tained at an assigned fail-safe value, last value
or configured fail - safe value.
The block output is directly set by the operator
through an interface device.
For forming the output value, the parameter
invert is used.
The block setpoint is being set by a Control
Application running on an interface
device through the remote cascade parameter
RCAS_IN.
Mode
out of operation (O/S) - MSB
manual (Man)
automatic (Auto)
remote - Cascade (RCas)