Installation And Commissioning - Burkert 8642 Manuel D'utilisation

5

INSTALLATION AND COMMISSIONING

Work on the device should only be carried out by specialist staff using the
correct tools!
Note that lines and valves must not be unscrewed from systems that are
under pressure!
Preferred fitting position: Attachment screws pointing downwards!
If EMV screwed fittings are used, position the screens according to
manufacturer's instructions!
On using a Weidmüller plugged connector for Profibus PA, the following
configuration applies:
Positioning
dimensions
B
S
On the front panel threads to M20 and M16 are provided; on the side a
thread to M16.
Before interfering with the system, always switch off the voltage supply!
The terminals may only be removed when not under voltage!
ATTENTION!
12 - 8642
View onto pin base and pins
Pin
A
n.c.
S
B
n.c.
A
The front panel is designed for a maximum of 5 changes.
The fixing screws of the front panel may be tightened with a
maximum of 1.5 Nm.
COUTION ON HANDLING!
ELECTROSTATICALLY
ENDANGERED COMPONENTS /
Colour PROFIBUS PA
blue PA-
black screen
brown PA+
not connected
ATTENTION!
MODULES!