Frequently Asked Questions; Troubleshooting - Martin Logan Sistine 4XC Mode D'emploi

F a
requentLY
How do I clean my speakers? Use a clean
cloth or a soft brush to remove the dust from your
speakers. Do not spray any cleaning agents on or
near the drivers.
What size amplifier should I use? We rec-
ommend an amplifier rated within the suitable
amplifier range of your speaker.
Could you suggest a list of suitable electronics
and cables that would be ideal for MartinLogan
speakers? The area of electronics and cable
choice is probably the most common type of
question that we receive. It is also the most
subjective. We have repeatedly found that brands
that work well in one setup will drive someone
else nuts in another. We use many brands with
t
rouBLeshooting
No Output
• Check that all your system components are
turned on, are not muted, and that your bal-
ance control (if applicable) correct.
• Check to make sure your power outlet at the
wall is working.
• Check your power cords, speaker wires, and
interconnecting cables.
• Check to make sure no headphones are
plugged in.
• Swap speaker wires at your amplifier with
those of a speaker that is functioning correct-
8
q
sked uestions
great success. Again, we have no favorites; we
use electronics and cables quite interchangeably.
We would suggest listening to many brands—and
above all else—trust your ears. Dealers are always
the best source for information when purchasing
additional audio equipment or cables and will
be well versed in the subject of special safety
requirements for in-wall cable.
Will exposure to sunlight affect the life or
performance of my speakers? We recommend
that you not place any loudspeaker in direct
sunlight. The ultraviolet (UV) rays from the sun can
cause deterioration of grille cloth and speaker
cones. Small exposures to UV will not cause a
problem. In general, the filtering of UV rays through
glass will significantly reduce the adverse effects.
ly. If the lack of output moves to a different
speaker the problem could be with other
equipment in your system (i.e., amp, pre-
amp, processor, and such).
• Try hooking up a different set of speakers.
The lack of output could point to a problem
with other equipment in your system (i.e.,
amp, pre-amp, processor, and such).
Lack of Bass or Poor Imaging
• Check your speaker wires. Is the polarity cor-
rect — (+) to (+) and (–) to (–).