ShelterLogic 95333 Instructions D'assemblage page 9

12. SecURe YoUR coveR
A. Install the "S"-hook from the ratchet assembly into the legs of
the shelter. Pull the webbing carefully to remove the slack from the
cover. Be careful not to pull the webbing through the opposite side
of the cover. Insert the webbing through the spindle of the ratchet
and pull tight. Wind the ratchet until the webbing overlaps itself.
Repeat these steps on the opposite side. Repeat this on the back
side of the shelter. When all of the corners are secured move the
cover front to back so that it is centered.When the cover is cen-
tered tighten all of the ratchets. Do this in an "X" pattern to be sure
it is tightened evenly. Fig. 12A & 12B.
B. When the cover is tight from end to end install the 45" cover
rails. Insert the cover rails into the pockets of the cover. Clamp
the rails to the ribs using the 3-way and 4-way clamps as shown in
Fig. 13 & 14.
C. Check that the rails are evenly spaced above the ground on
both sides. Push down on the connectors, one at a time, to tighten
the cover. Tighten the bolts to the cover in place and tight on the
frame.
FRonT
End Rib Cross Rail Clamps
11106
11130
00690
11182
11105
COvER RAILS
Fig. 13
11112
11105
11105
00690
NOTE: The ShelterLogic
Middle Rib Cross Rail Clamps
Fig. 14
11107
11130
00690
Page 9
Thread Webbing Into Ratchet
Fig. 12A
Webbing and Ratchets Securing Cover
be oriented as shown below.
11105
logo should
®
ReAR
Fig. 12B
05-95333-95334-0C