Publicité
Les langues disponibles
Les langues disponibles
4. ATTAcH BASe FeeT To MIDDle RIBS
Insert a base foot plate into each end of the middle rib pipes.
After installing the base feet line up the holes in the leg to the holes in
the feet and secure with the hardware indicated in Fig. 4.
5. ASSeMBle WInD BRAceS
Assemble all of the wind braces as shown in Fig. 5.
Securely fasten all of the joints with the hardware
indicated.
6. InSTAll SIDe RAIlS AnD SHelTeRlock™
STABIlIzeR BlockS
With help, move the first end rib into the desired staked area.
Place the ShelterLock™ on the upright as shown in Fig. 6.
From the outside of the rib insert the bolt through the upright and then
through the ShelterLock™.
Place the plain end of the side rail over the bolt and nest it into the
ShelterLock™.
Install the nut onto the bolt and tighten.
Repeat these steps for the opposite side and all of the remaining ribs.
The side rails for the last rib will have two plain ends.
11005
Page 5
11112
Fig.4
800057
11131
11179
Use #00648 5/16" x 2" Bolts
Fig.5
800372
800454
00690
05-95333-95334-0C
00690
Fig.6
Publicité
