ShelterLogic 95333 Instructions D'assemblage page 4

1. ploTTInG THe AReA FoR THe FRAMe:
A. Stake out the area for the frame in the desired spot. Ensure that the
shelter measures the purchased length and width. Measure diagonally
from corner to opposite corner (A), and repeat this measurement with
the remaining two corners (B).
B. To ensure the building is squared, both A and B measurements
should be the same. Check the rectangle's length and width once
more, as they may have changed during the squaring-up procedure.
Once length and width are verified, and measurements A and B are
equal, your shelter should be square.
2. ASSeMBle enD RIBS
Assemble end ribs as shown in Fig. 2. Securely
fasten all of the joints with the hardware indicated.
3. ASSeMBle MIDDle RIBS
Assemble middle ribs as shown in Fig. 3. Securely
fasten all of the joints with the hardware indicated.
Fig.1
11113
11051
11182
11113
11051
11112
Page 4
14 ft.
WIDTH
A
B
11114
11113
#11131
5/16"x2 3/4"
Bolts
11051
Fig.2
11114
11113
#11131
5/16"x2 3/4"
Bolts
Fig.3
05-95333-95334-0C
28 ft.
LENGTH
11182
11051
11112