ShelterLogic 95333 Instructions D'assemblage page 8

11. InSTAllInG THe coveR on THe FRAMe
A. Lay the cover on the ground next to the
frame with the inside of the cover (the side
with the pipe pockets) facing down and the
webbing on the front and rear of the corner
of the building. Position the cover so that it is
centered on the frame, front to back. Fig. 11A
B. Fold over the side closest to the frame so
the pipe pocket is now accessible. Insert a
Fig. 11A
cover pipe at the first middle rib from the front
and the first middle rib from the rear so that it
is inserted in the pipe pocket on both ends of
the pipe but the center of the pipe is exposed.
For long buildings it may be necessary to use
additional pipes in the middle. Fig. 11B.
C. Tie the rope on each of the exposed pipes
and throw the other end of the rope over the
frame. Fig. 11C.
D. Move to the other side of the frame and
pull the cover over the frame with the rope.
This may require two or more people.
Fig. 11D
Fig. 11B
Fig. 11C
Fig. 11D
Page 8 05-95333-95334-0C