Publicité
Les langues disponibles
Les langues disponibles
7. InSTAll WInD BRAceS
Take the wind brace and attach it between the end rib and
the first middle rib as shown in Fig. 7.
Any attachments at the cross rails should be made on the
very inside of the cross rail.
8. InSTAll Top RAIl
Place the first top rail under the end rib and secure it with a bolt as shown in Fig. 8.
The same cross rail should lay on top of the first middle rib as with all of the middle ribs.
Secure the rails to the frame with the hardware indicated in Fig 8.
The top rail attached to the last rib will be installed under the pipe as the initial end rib.
Top Cross Rail UNDER End Ribs
800454
00690
9. InSTAll AUGeR AncHoRS
Using a ¾" pipe or steel rod (a car tire iron works also) placed
through the eyelet of the auger; screw the anchor into the ground.
Start at the corners of the shelter and space the remaining anchors
evenly along the length of the shelter.
Screw the anchor into the ground until the eyelet is sticking out of
the ground by 1-2" so it can be anchored to the legs.
Wrap the cable provided through the eyelet of the anchor and
around the frame as indicated in Fig. 9. Secure the cable with the
clamps provided.
Wind
Brace
Fig.7
11005-11179
Fig.8
Page 6
Wind
Brace
11005-11179
Top Cross Rail OvER Middle Ribs
11133
00690
Fig. 9
05-95333-95334-0C
Publicité
