Moulinex SLIMFORCE DD853810 Mode D'emploi page 15

• If your appliance "jams" during processing, switch it off and check that the
accessory used is not overloaded with ingredients. Carefully remove the
ingredients obstructing the blades.
• Your appliance is equipped with a device to protect against overheating. If
your appliance overheats, it will switch itself off. Leave it to cool down for
about 20 minutes then start using it again.
USING THE APPLIANCE
• Before using your appliance for the first time, clean the accessories using warm
water and washing-up liquid. Rinse and dry them carefully.
• Ensure that your work top is stable and dry.
• Place the ingredients in a container that is tall enough to avoid splashing.
• Do not fill the jug (D) to more than 500 ml (18 fl oz) to avoid splashing.
• Do not operate the mixing foot (C) at turbo speed for more than 20 seconds.
• Mixer foot: FIG 2 & 3
- Screw the blender foot (C) onto the motor unit (A), and ensure that the foot is
screwed on completely before plugging in the appliance. FIG 2.
- Insert the blender foot (C) halfway down into the container FIG 3 and press the
speed start button (B1 or B2). The preparation must at least cover the hand
blender head to ensure efficient operation of the appliance.
IMPORTANT: Do not operate the appliance when empty.
- Before mixing hot preparations, remove the container from the heat source. For
best results, there is no need to move the mixer foot around in the preparation.
Instead insert the foot in the centre of the container with the blender head
submerged halfway down in the food.
- For stringy ingredients (leeks, celery, etc.), clean the foot regularly during the
preparation, ensuring that you follow the safety instructions for dismantling
and cleaning the appliance.
- When making fruit-based preparations, slice the fruit and remove the cores and
any stones beforehand.
- Do not operate the appliance to prepare hard ingredients (sugar, chocolate,
coffee, ice-cubes).
• Mini chopper 150mL (depending on model): FIG E & 4
- Fit the blades (E2) onto the drive pin of the bowl (E1).
- Place the ingredients in the bowl (E1) then fit the inner cover (E3) then the lid
(E4).
- Fit the motor unit (A) onto the lid (E4).
15
EN