CLAS PE 2002 Mode D'emploi page 61

PE 2002 PE 2006
THE FOLLOWING IS ALLOWED:
• Using lift only to lift vehicles for inspection, maintenance and/or repair operations.
• Using lift only to lift vehicles respecting capacity limits and loads distribution indicated in this
manual.
• Only authorised personnel, in good health conditions, responsible and duly trained on the
allowed uses and risks originated by lift use may operate the lift.
•
The operator is allowed to use the vehicle lift only after he has thoroughly read, understood
and assimilated the contents of this manual.
•
Using lift only inside closed premises, protected against atmospheric agents such as: rain,
snow, wind, etc...
• Only one operator at a time may use the lift in the safety position in the indicated area, close
to the control panel.
IT IS COMPULSORY:
• Lift installation and maintenance operations shall be compulsorily carried out by qualified
personnel only, and in full compliance with the instructions given in this manual.
Before installing lift, you shall compulsorily check that the premises where you wish to position
•
it are well aerated and lit. (avoid blinding light sources).
You shall compulsorily check that the floor where you wish to install lift is solid, flat, and
•
perfectly levelled in all directions.
•
You shall compulsorily check that the floor has been constructed to withstand the max. allowed
loads, including the lift, on lift resting areas.
• Lift shall be compulsorily positioned far from heat sources or devices that could generate
electromagnetic radiation.
Lift shall be compulsorily positioned so that, during standard operation, with the vehicle loaded
•
on it, it does not interfere with or squash any nearby fixed or moving part. Take special care to
power, water and gas systems.
•
The lifting or handling operations of lift or of any lift parts shall be compulsorily carried out
under full safety conditions with suitable lifting equipment, as envisaged by the National
prevailing regulations.
• Lift shall be compulsorily secured to the floor only using anchors and screws of the type
recommended by the manufacturer (for lifts, where envisaged).
•
Before using the lift, the wholeness of lifting elements shall be compulsorily checked.
• Before using the lift, you shall compulsorily check that safety devices are perfectly installed
and in good operating conditions.
• Vehicle shall be compulsorily positioned as shown in the table of the manual and/or the table
stuck to lift.
• Vehicle shall be compulsorily lifted from the resting points specified by the vehicle manufacturer.
When moving vehicle up, after the first 200 mm and before continuing the raising, load stability
•
shall be compulsorily checked in all directions.
•
During the whole raising movement, load stability and lift correct and linear movement shall
be compulsorily checked.
Before accessing the working area, lift shall be compulsorily put in mechanical safety position
•
with the special command (where applicable).
• Before accessing the working area, lift shall be compulsorily disconnected from power sources
by turning to 0 (zero) the lockable rotating disconnector positioned onto control panel.
PE 2007
61