Publicité
IMPORTANT SAFETY INSTRUCTIONS
This appliance conforms to the relevant safety
regulations.
Repairs should only be made by qualified specialists.
Repairs made improperly can result in significant
hazards for the user.
Your new appliance was protected by the
packaging during shipping. None of the materials
create pollution and all of them can be recycled.
Please help protect the environment by disposing
of the packaging in an environment-friendly
manner.
You can get information about the best method
for disposing of old appliances and packaging
from your dealer or local municipal council.
Check whether this fan may be combined with
the extractor hood.
SAFETY WARNING: Before servicing or cleaning
the unit, switch the power off at the service panel
and lock service disconnecting means to prevent
power from being switched on accidentally.
When the service disconnecting means cannot
be locked, attach a tag to the service panel to
indicate that the power has been switched off for
maintenance.
WARNING – TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
IMPORTANT INFORMATION:
Read and follow the installation instructions and warnings of the blower group!
The unit must be qualified sealed to the roof, e.g. screws, pipe connections, roof cutout, etc.
Caution: The sides of the roofplate may have sharp edges. Risk of injury!
We recommend wearing protective gloves for mounting.
Equipment needed
K Drill and bit
K Screwdriver
READ AND SAVE THESE INSTRUCTIONS.
PAGE 3
A.
Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-related construction.
B.
Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel-burning equipment to prevent
backdrafting. Follow the heating equipment
manufacturers' guidelines and safety standards
such as those published by the National Fire
Protection Association (NFPA), the American
Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE),
and local code authorities.
C.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
D.
To properly exhaust air, be sure to duct air out
side. Do not vent exhaust air into spaces inside
walls, ceilings, attics, crawl spaces or garages.
WARNING: To reduce the risk of fire, use only
metal ductwork.
CAUTION – For general ventilation use only.
Do not use to exhaust hazardous or explosive
materials and vapors.
This unit must be grounded.
WARNING: To reduce the risk of fire or electric
shock, do not use this fan with any solid-state
speed control device.
Equipment included
K Anchors (16)
K Screws 5 x 40 (16)
K Screws 3.9 x 9.5 (8)
Publicité
