Initial Use; Operation - Sanitas SIH 21 Mode D'emploi

5. Initial use

Setup
Remove the unit from the packaging. Place it on a flat
surface.
Ensure that the ventilation slits are free.
Fold open the lid [2] to access the accessories.
Before using the unit for the first time
Note
• The atomiser and accessories must be cleaned and
disinfected before they are used for the first time. For
information about this, see "Cleaning and disinfec-
tion" on page 16.
• Attach the compressed-air hose [8] at the bottom of
the medicine container [11].
• Connect the other end of the hose [8] to the hose
connector [6] on the nebuliser by lightly turning it.
Mains connection
Connect the unit only to the mains voltage listed on
the type plate.
• Insert the mains cable plug [1] into a suitable socket.
• Push the plug completely into the mains socket.
Note
• Ensure that there is a socket near to where the unit
will stand.
• Lay the mains cable in such a way that no one can
trip over it.
• To disconnect the nebuliser from the mains after use,
first switch off the device and then remove the plug
from the socket.

6. Operation

Caution
• For hygiene reasons, the atomiser [9] and the ac-
cessories must be cleaned after each treatment and
disinfected after the last treatment of the day.
• The accessories may be used only by one person;
use by several people is not recommended.
• If several different medicines are to be inhaled in suc-
cession during therapeutic use, the atomiser [9] must
be rinsed under warm tap water after each use. For
information about this, see "Cleaning and disinfec-
tion" on page 16.
• Follow the instructions for changing the filter con-
tained in these instructions.
• Before each use, check that the hose connections
on the nebuliser [6] and the atomiser [9] are tight.
• Before use, check that the device is functioning cor-
rectly. To do this, switch on the nebuliser (including
the connected atomiser, but without any medication)
for a short time. If the atomiser [9] expels air, the
device is functioning correctly.
1. Inserting the nozzle attachment
• To open the atomiser [9], twist the upper section anti-
clockwise against the medicine container [11]. Place
the nozzle attachment [10] in the medicine container
[11].
• Ensure that the cone for administering medication fits
well on the cone for the air duct inside the atomiser
[9].
2. Filling the atomiser
• Pour an isotonic saline solution
or the medicine directly into the
medicine container [11]. Do not
overfill! The maximum recom-
mended fill level is 8 ml !
• Use medication only on the advice
of a physician, and check the ap-
15