Setting Of Closing Limit; Force Learning Activation; Setting Force Level - Key Automation VIPER Instructions Et Avertissements Pour L'installation Et L'usage

4.9 Setting of closing limit

Press"+" to display "2"
When the door closes and
reaches the ideal position, after
2 seconds press the key "P" to
save the information.

4.10 Force learning activation

Press"+" to display "3"
Door closes auto-
matically

4.11 Setting force level

Note: in order to exit the programming and save the parameters push P button for 5 seconds.
Press"+" to display "4"
High
When programming is finished the door must make a full cycle before usage, this cycle is used to learn the force after the
modification made.
Press "P", "2" will flash
Press "P", "3" flashes
Press "P" to save the settings
Press "P", " " flashes
Default setting
Force level
Press"+"
Or press "-"
Attention!! In order to avoid false obstacles detection in closing while
programming the motor it is strongly recommended to release the but-
ton as soon as the door touch the ground.
The door opens automatically
Press"+", or press"-"
to select the level
Door closing
Or door opening
Press "P" when door stops,
then again press "P"
Press "P" to save the settings
Low
EN
21