Armytek Heater Manuel D'utilisateur page 2

ENG USER MANUAL
Thank you for choosing the products of Armytek.
please read this manual carefully before using the flashlight.
Specifications
Model
LED/Optics
Brightness stabilization type
Light output
Peak beam intensity
Hotspot : Spill
Beam distance
Modes, light output and runtimes (measured
with 18650 Li-Ion 3500 mAh battery until the
light output drops to 10% of the initial value)
Power source
Length/Body diameter/Head diameter
Weight without/with battery
Dust, water and impact resistance
X Light output for flashlights with Warm light is about 7% less, beam distance is about 3% less. All the above specifications are test results based on ANSI/NEMA FL1-2009 Standard. The tests are
performed using the battery included in the set. The data may vary due to environment, heat dissipation and other factors.
• Special precisely calculated reflector for High Intensity LEd modifi-
cation, which provides 1.5 times the light range compared to a usual
LEd, and tempered glass with anti-reflective coating for maximum
throw create clear central spot with minimal side spill at 1500 lumens
brightness. Spill diameter is 9 meters at 100 meters distance
• powerful electronics provides constant brightness even at a tem-
perature of -40 °C and not fully charged battery
• Two types of operation: hunting and tactical. Tactical operation for
quick access to maximum brightness mode and Strobe mode
• Withstands any recoil due to improved springs and installation of the
driver inside a reinforced capsule filled with protective compound
• Standard 1 inch body is compatible with any accessories, including
original magnetic remote switch and magnetic mount for quick
one-motion attachment and removal
• Two-phase electronic button retained two levels of pressing similar to
mechanical switch, but became noiseless and 20 times more durable
• Non-flat button allows to easily switch the flashlight with a palm
2 ENG USER MANUAL pREdAToR pRo
Turbo
Main3
Main2
Main1
Strobe2
Strobe1
Predator Pro (White)
Cree XHp35HI/Smooth reflector
FULL (constant light)
1500 lm
62800 cd
5°:40°
501 m
1500 lm/1 h 33 min (700 lm after 3 min)
300 lm/5 h 13 min
120 lm/12 h 20 min
40 lm/32 h
1500 lm/15 Hz/3 h (700 lm after 3 min)
120 lm/15 Hz/23 h
1x18650 Li-Ion
160 mm/25.4 mm/41 mm
136 g/186 g
Ip68. Submersion at 25 m up to 5 h. Fallings from 25 m
• Innovative technology allows using any standard 18650 Li-Ion bat-
teries with 10A discharge current and provides full protection against
short circuit even in case of contact between magnetic connector and
metal objects
• Solid body made from aircraft-grade aluminium, special matt anti-
abrasive finish without rough knurling
• Steel striking bezel with matt non-reflective black titanium coating,
which prevents location disclosure, is used for additional protection of
the optical system in the event of a fall and as a shock-crushing tool
• Active real-time temperature control to prevent overheating above
+58 °C and warning indication of low battery level
• Total protection from water, dirt and dust in accordance with Ip68
standard — flashlight continues to work even at 25 meters depth up
to 5 hours. Withstands fallings from the 10th floor
• Robust and water resistant magnetic connector
REV_00-0000