Installation - Alpine DVA-9861 Mode D'emploi

Installation

Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
(Rear side)
Accessory List
• Head unit .............................................................................1
• Power cable.........................................................................1
• Mounting sleeve ..................................................................1
• Carrying case ......................................................................1
• Bracket key..........................................................................2
• Screw (M5x8).......................................................................4
• RCA extension cable (Video) (2m) ......................................1
• Remote control ....................................................................1
• Battery (CR2025).................................................................1
• Owner's Manual .............................................................1 set
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Less than 35°
1
Mounting Sleeve
(Included)
This unit
Remove the Detachable Front Panel (refer to page 8).
Slide mounting sleeve from main unit.
(see "Removal" on page 64).
Slide the mounting sleeve into the dashboard.
Dashboard
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*) already
attached to the vehicle's chassis.
• For the screw marked **, use an appropriate screw for the
chosen mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the DVA-9861. Connect all other
leads of the DVA-9861 according to details
described in the "Connections" section.
3
Slide the DVA-9861 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Install the Detachable Front Panel.
Screw
**
Bolt Stud
*
This unit
Chassis
63
-EN