Dvd/Video Cd; Playing A Disc - Alpine DVA-9861 Mode D'emploi

DVD/Video CD

In this section, both remote control and main unit operation are
described.
SOURCE/
(OPEN)
POWER
DN
RETURN
/
MENU
CLR
DISP./TOP M.
AUDIO
• DVD/Video CD operations can be performed from both the remote
control and the main unit. In this section, both remote control and
main unit operations are described.
• To view DVD/Video CD, the optional TV monitor is required.
• DVA-9861 automatically changes the video output signal (NTSC or
PAL), according to the disc. To set NTSC or PAL on the connected
monitor, refer to the Owner's Manual of the monitor.
Disc types that can be used for each heading are
represented by the following marks.
DVD Commercial Audio discs can be used.
DVD Commercial Video discs (used for the
distribution of movies, etc.) or a DVD-R/DVD-
RW/DVD+R/DVD+RW recorded in a video
mode can be used.
DVD-R/DVD-RW discs recorded in DVD-VR
mode can be used.
Video CD discs can be used.

Playing a Disc

/
Play Position Memory Function
4
Even if you turn power off or switch the Ignition Key to OFF during
playback or change the source, playback will continue from the point
where playback stopped when the power is turned ON again.
UP
1
2
ENT.
Numeric
keypad
(0 to 9)
ANGLE
SUBTITLE
*
*
*
3
• Do not remove a disc during its eject cycle. Do not load more than
• If the disc does not eject, press and hold
• The reverse side of a double-sided DVD will not be played
• Never insert map discs for navigation purposes as they could damage
• Refer also to "DVD Setup" (pages 26 to 28).
Caution
• Not all functions will operate for every DVD. See the individual
DVD's instructions for details on the features supported.
• Fingerprints on a disc may adversely affect playback. If a
problem occurs, remove the disc and check for fingerprints on the
playback side. Clean the disc if necessary.
• When using the remote control, be careful to press only one
button at a time. Pressing multiple buttons at the same time may
cause erroneous operation.
• If you try to perform an invalid operation (based on the type of
disc being played), the following mark is displayed on the
monitor screen:
Press (OPEN).
The front panel will open.
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Close the front panel manually.
When a disc is already inserted, press SOURCE/POWER
on the main unit to switch to the DISC mode.
TUNER XM RADIO/SIRIUS*
3
CHANGER* TUNER
1
Only when XM Radio or Sirius Radio is connected.
2
Only when the iPod is connected.
3
Only when the CD changer is connected.
To eject the disc, press
to open the front panel.
one disc at a time. A malfunction may result from doing either.
automatically. Remove the disc, turn it over, and reinsert it.
the equipment.
1 2
DISC IPOD*
after pressing (OPEN)
for at least 2 seconds.
15
-EN