Publicité
Les langues disponibles
Les langues disponibles
5
Installing the IntelliBrite
Coil at least
7.
to be serviced after the pool is filled with water.
8. Install the light assembly into the pool niche. IMPORTANT: Be sure to
insert the TAB on the lower part of the face ring into the niche SLOT
(located on the lower part of the niche). This is important to secure the
lower part of the light assembly onto the niche before tightening the
pilot screw.
9. Carefully tighten the special bronze pilot screw to secure the upper part of
the light assembly onto the niche.
underwater light. This screw mounts and electrically grounds the housing
securely to the mounting ring and wet niche. Failure to use the screw
provided could create an electrical hazard which could result in death or
serious injury to pool users, installers or others due to electrical shock.
10. Final check for proper IntelliBrite light operation: Switch on the main
switch or circuit breaker to the system, and the switch that operates the
IntelliBrite underwater light itself. The light should illuminate when power
is applied. If not recheck the installation steps again.
INTELLIBRITE
5G Pool and Spa Lights Gasket Kit Installation Guide
®
Gasket and Uni-Tension Wire Clamp
of cord around the light fixture. This allows the light
4 ft (1.22 m)
Use only the special pilot screw provided with this
Face ring TAB (insert
®
5G Pool Light Fixture
into niche slot)
Publicité
