Publicité
Les langues disponibles
Les langues disponibles
Installing the IntelliBrite
4.
INSTALL UNI-TENSION WIRE CLAMP: With the hook ends of the circular Uni-
Tension Wire Clamp pointing down, spread the clamp and place it in the "U" recesses
of the locking levers. Be sure the hook ends of the clamp are located between the pair
of locking levers as shown below and that the wire clamp is properly engaged with all
of the lock levers.
5.
Place a cloth on the ground to protect the lens. Turn the light over so the lens is resting
on the cloth. Be sure the orientation of the wire clamp and the bolt connection is
positioned at 45° from the pilot screw.
6.
Tighten the bolt and nut until both ends meet (touching is optimal). Note: A tolerance
distance of 3/16" (4.8 mm) or less between the ends of the clamp is also acceptable.
Continue on next page.
"TOP" label
(use to align light
housing with pilot
screw on face
PILOT
SCREW
Position the wire clamp (nut and bolt) about 45°
between the PILOT SCREW and BOLT/NUT.
Gasket and Uni-Tension Wire Clamp
INTELLIBRITE
®
5G Pool Light Fixture
PILOT SCREW
(12 o'clock)
"W" ON LENS
BRASS NUT
Align letter "W" ("WIDE"
angle) on lens/gasket
with pilot screw hole on
face ring and brass nut
For "NARROW" angle
light beam, rotate "N" to
12 o'clock position
3/16 in (4.8 mm) or less
5G Pool and Spa Lights Gasket Kit Installation Guide
®
4
Uni-tension
Wire Clamp
Lock
lever
Publicité
