Pentair 620400Z Guide D'installation page 2

1
Installing the IntelliBrite
®
IntelliBrite 5G Pool Light Gasket Kit (P/N 620409)
This manual describes how to install a gasket (P/N 620400Z) and uni-tension wire clamp
on to the IntelliBrite 5G pool light. Note: For more information see the IntelliBrite 5G
pool and spa light Instllation and User's Guide (P/N 620278).
Note: To be certain that the pool or spa electrical system meets all applicable
requirements, the electrician should also consult the local building department.
Note: Use only Pentair wet niches to insure proper bonding and grounding connections.
The following removal and installation instructions describe how to remove and
install the IntelliBrite pool light assembly and install a new gasket and uni-tension
wire clamp.
Failure to bring the pool or spa's electrical system up to code requirements
before installing the underwater light will create an electrical hazard which
could result in death or serious injury to pool users, installers, or others due
to electrical shock, and may also cause damage to property.
1. Switch off main electrical switch or circuit breaker, and the
switch which operates the IntelliBrite underwater light.
• Do not service the light while in the pool water. Service the
light on the deck.
light assembly. Failure to do so may permit water to leak into the assembly which
could cause:
(a) an electrical hazard resulting in death or serious injury to pool users, installers,
or others due to electrical shock, or
(b) breakage of the lens, which likewise could result in serious injury to pool users,
installers, or bystanders, or in damage to property.
INTELLIBRITE 5G Pool and Spa Lights Gasket Kit Installation Guide
®
Gasket and Uni-Tension Wire Clamp
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Always disconnect power to the pool light at the circuit breaker
before servicing the light. Failure to do so could result in death
or serious injury to installer, service person, pool users, or
others due to electrical shock.
Always install a new lens gasket (P/N 620400Z) and
Wire Clamp (P/N 600095)
®
5G Pool Light Fixture
D A N G E R !
whenever disassembling the IntelliBrite
Uni-Tension