Pentair 620400Z Guide D'installation page 4

3
Installing the IntelliBrite
INSTALL THE NEW GASKET
1.
ON TO THE LENS: Stretch the
gasket around the circumference
of the lens. Be sure the gasket is
installed evenly around the lens.
IMPORTANT NOTE: Install the
gasket so that the flat edge
side of the gasket is towards
the inner surface of the face
ring and the Black embedded
o-ring must be between the
lens and the light housing.
Note: The letters TOP are
embossed on the flat edge
side of the gasket.
2. ALIGN THE LENS AND
GASKET ON TO THE LIGHT
HOUSING:
a) With the light housing
resting on its base, place the
lens/gasket on top of the light
housing.
b) Rotate the lens/gasket to
align the letter "W" ("WIDE"
angle) on the lens with the brass
nut in the housing (see diagram
on page 4 for brass nut location).
3. INSTALL THE FACE RING:
Place the face ring on top of
the lens/gasket/housing. Rotate
the face ring so the pilot screw
hole is aligned in the 12 o'clock
position, with the lens letter "W"
(or "N") and the brass nut in the
housing. Also, verify the "TOP"
position arrow indicator label
(see page 4) on the rear of the
housing is aligned with the pilot
screw on the face ring.
INTELLIBRITE 5G Pool and Spa Lights Gasket Kit Installation Guide
®
Gasket and Uni-Tension Wire Clamp
5G Pool Light Fixture
®
BLACK
O-RING
GASKET
UNI-TENSION
WIRE CLAMP
INSIDE OF
FACE RING
LENS
LIGH T
HOUSING
GASKET
LENS
Uni-Tension
Wire Clamp
FACE RING
LIGHT HOUSING
Gasket
(Flat edge
towards the
face ring
- TOP is
embossed
on the top
side of the
gasket)
Gasket
flat edge
is towards
the inner
surface of
face ring