Proxxon LB/E Mode D'emploi page 9

If you would like to manually guide the device
while working, hold it like a ballpoint pen
when milling or engraving. Do not cover the
ventilation slits. For coarser work, hold the
device as though it were the shaft of a ham-
mer.
An ideal working environment is achieved if
the device is clamped by its 20 mm fit into an
upright of sensitive drill (see fig. 6), a univer-
sal base attachment or comparable mecha-
nism.
A diversity of additional fields of application
is supplemented if the LB/E is combined with
other machines and devices!
Accessories:
A comprehensive range of accessories is list-
ed in our equipment catalogue!
Service and maintenance:
Caution:
Pull the mains plug before making any ad-
justments, performing maintenance work, or
carrying out repairs!
The scroll saw is basically maintenance free.
However, to ensure a long service life you
should clean the device after each use with a
soft cloth or brush.
External cleaning of the housing can be car-
ried out using a soft, possibly moist cloth.
While doing so, a mild detergent or other
suitable cleansing agent can be used. Do not
use solvents or cleansing agents containing
alcohol (e.g. benzene, cleaning alcohol, etc.)
as these can corrode the plastic housings.
Note:
Disposal:
Please do not dispose of the device in do-
mestic waste! The device contains valuable
substances that can be recycled. If you have
any questions about this, please contact
your local waste management enterprise or
other corresponding municipal facilities.
Declaration of EC conformity
We declare with sole responsibility that this
product conforms with the following EC reg-
ulations:
EU low voltage directive 2006/95/EG
DIN EN 60745-1 / 06.2007
EU EMC-directive Applicable standards
2006/66/EG
DIN EN 60745-1 / 06.2007
EU machine directive 2004/108/EG
DIN EN 55014-1 / 06.2007
DIN EN 55014-2 / 08.2002
DIN EN 61000-3-2 / 10.2006
DIN EN 61000-3-3 / 06.2006
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Unit Safety Departement
- 9 -