Adjusting The Presser Foot Pressure (Presser Foot (Asm.)) And The Height Of The Presser Foot (Presser Foot (Asm.)) - JUKI DLN-6390 Manuel D'utilisation

8. Adjusting the presser foot pressure (presser foot (asm.)) and
the height of the presser foot (presser foot (asm.))
Adjusting the presser foot pressure
Adjusting the height of the presser foot
3
4
C
32
2.5 to 3.5 mm
2
3
A
1
Turn dal 2 to adjust the presser foot pressure of presser
foot (asm.) 1 n the drecton of arrow mark A at the tme
of sewng. (Adjustng value at the tme of delvery : shaft
protrudng amount : 2.5 to 3.5 mm)
• Tghtenng dal 2 clockwse ncreases the presser foot
pressure.
• Tghtenng dal 2 counterclockwse decreases the
presser foot pressure.
＊ When the presser foot pressure s excessvely hgh,
the feed force wll deterorate. When the presser foot
pressure s excessvely low, sewng performance wll
be not stablzed.
Set the protrudng amount of 3 mm as the standard
and perform fine adjustment within the range where
sewng performance or feed force s not affected.
＊ After adjustng dal 2 , turn dal 3 wth dal 2 fixed and
fix the presser foot.
Adjust the heght B of the presser foot (asm.) when
the presser foot goes up by loosenng setscrew 3 and
changng poston C of hand lfter base 4 n the vertcal
B
drecton.
(Adjustng value at the tme of delvery : 2.5 mm)
• Lifting the fixing position of hand lifter base 4
ncreases heght B of the presser foot.
• Lowering the fixing position of hand lifter base 4
decreases heght B of the presser foot.
＊ The top end of the needle protrudes from the bottom
surface of the presser foot even when the presser foot
s lfted when the sewng machne stops at UP poston
n the case where the heght of the presser foot s more
than 2.5 mm. As a result, cloth may be damaged by
the top end of the needle.
When the heght of the presser foot s 2.5 mm or
less, cloth comes n contact wth the presser foot when
placng t on the sewng machne or removng t from
the sewng machne at the tme of sewng. As a result,
operating efficiency will deteriorate.
＊ Adjust the heght of hand lfter base 4 so that the
heght of the presser foot should be wthn the range
of 2 to 4 mm. After the completon of adjustment,
securely tghten setscrew 3 . (Tghtenng torque : .5
to 2.5 N·m)